• June 29. 2022

Nonmetallic seals that are exposed to retained fluids shall undergo the design validation procedure described in API 6A Annex F.1.13. To meet with the Thermochemical Performance of Seal Materials required by API 6A Annex F, a variety of JST compounds including HNBR, FKM, PTFE, PEEK compounds are successfully certified by third party Alpine Polytech. Sour Gas Immersion FF/HH: Gas Phase: 35% by volu...

• June 29. 2022

The requirements of hydraulic system for reliability are increasing day by day, and the working conditions of the continuously developing high-efficiency hydraulic system become more complicated. Therefore, when selecting the most suitable material, it is very important to be familiar with the working conditions, such as working temperature and pressure, load, speed and medium. The most commonly u...

• June 24. 2022

The T-seal is developed to replace the existing O-ring in the long-life hydraulic and pneumatic system, because the O-ring rolls in the sealing groove, which is easy to cause screw failure. Their ability to fit into existing grooves means they can be retrofitted without rework or major modifications to existing hardware designs, simplifying field changes and new equipment manufacturing. The T-seal...

• June 20. 2022

With the development of fracturing and acidizing application technology, fracturing pumps with high pressure and large flow are required. The working condition of fracturing pump is extremely bad: high pressure, high acidity, high sand content and high sand hardness. Poor working conditions make the service life of the plunger pump seals short and the maintenance frequent. Sometimes, the seals mad...

• June 17. 2022

Valve insert is a necessary and vulnerable part of oil well fracturing pump in oil field. It forms a valve assembly with valve disc, valve cover, valve seat, guide claw, worm thread, nut, etc. when working, valve insert plays a role of sealing and buffering. Oil field special valve insert seal is mainly used in pumps, which functions as water inlet valve and drainage valve. Features: oil and corro...

• June 10. 2022

JST produces different material spring energized lip seal. Jacket material such as PTFE, PEEK, TFM. Spring material include 316ss or Alloy spring. For different working conditions, we use different seal designs and materials. If seal works at pressure over 6000PSi, PEEK back up ring is needed. For -196°C, we would use material TFM+Alloy spring. JST has ability to produce different dimensions of sp...

• June 09. 2022

FS casing and tubing seals are uniquely designed sealing elements that provide excellent sealing in areas where high seal deflection is required. The design features of this seal allow the component to compensate for changes in piping, housing, or large diameter parts. The use of metal clamping springs provides extrusion resistance. The open coil has no initial tension during manufacturing, so the...

• June 02. 2022

There are many reasons for seal failure, including long-term storage in less than ideal conditions. Rubber may crack, harden, soften or degrade, making it unsafe for its intended use. Most seals have a widely accepted shelf life, which helps manufacturers prevent catastrophic failures caused by old seals. Maintaining the seal throughout its intended shelf life requires providing a storage environm...

• June 01. 2022

Hydraulic cylinders are used to perform work in a variety of different situations and applications on a daily basis. In order to contain pressurized fluid and maintain its movement in the hydraulic cylinder system, two basic types of complex configurations of high-performance seals are required: static seals and dynamic seals (supported by guide rings). There are certain types of seals in each cat...