Bonded seals for completion tools

T-seals are three piece seals with an elastomeric lip and hard plastic anti-extrusion rings, it is proved to be of long time service. The standard design will fit into an o-ring gland and can be machined or net moulded.

PDR rotary shaft seal extends the boundaries of elastomeric radial shaft seals, utilizing advanced materials and design techniques to provide optimal sealing performance for each application. The result is a superior sealing solution that retains a compact sealed casing.

The FS-seal is a relatively large cross section spring energized elastomer casing and tubing hanger seal for wellheads that always has the springs on the internal surface.

JST manufactures well service plunger pump packings in a wide variety of materials to suit specific well conditions and operating parameters, they are available in a wide range of elastomeric materials and high performance resins, including NBR, HNBR, FKM, filled PTFE, fabric reinforced rubber.  to suit specific well conditions, operating parameters, and fracturing fluids.

S Seals are well suited for sealing wellheads, connectors, downhole tools, high pressure valves and other demanding oil and gas applications. The non-extrusion springs can be fabricated from different metals.The S seal is made of spring and rubber material could be NBR, HNBR, FKM ect.

A glass filled nylon wear ring, also called wear band, offers high bearing load capacity over a broad range of temperatures.

Phenolic wear rings are designed with tubing made from fine weave cotton fabric wound on molds and imbued with phenolic resin. It has high mechanical properties, good oil resistance, low water absorption and high wear resistance.

DKBI wipers are installed in the sealing configurations of hydraulic cylinders to prevent contaminants such as dirt, dust and moisture from entering the cylinder as they retract back into the system.