PEEK V stacks for downhole tool

V-Packings are used in various Oilfield Downhole equipment such as various Valves etc. V-Packings are extremely suitable for usage in medium to heavy duty applications. Vee Packings accept low and high pressure while operating in the most extreme conditions and also if there exists any misalignment between the sealing gaps.

A seal assembly for use in a wellbore tool, it acts as a flow restrictor protecting a lower end of the seal assembly from high pressure and/or high volume flow.

T-seals are three piece seals with an elastomeric lip and hard plastic anti-extrusion rings, it is proved to be of long time service. The standard design will fit into an o-ring gland and can be machined or net moulded.

High-pressure Rotary shaft seals are one bidirectional rotary seal which can bear both sides of pressure and alternating pressure. It is made with slip ring and o-ring/square ring.

Wellhead secondary pack off seal is used to seal the hanger to the wellhead.

Rod seals are static seals installed in glands or housings to prevent the leakage of fluid from within a cylinder to the outside as the rod cycles.

SPGW is a high performance, double acting compact piston seal, to seal in fluid, thus preventing the flow of fluid across the piston, allowing pressure to build up on one side of the piston.

The FS-seal is a relatively large cross section spring energized elastomer casing and tubing hanger seal for wellheads that always has the springs on the internal surface.